Main Geometric Angles of Indexable Milling Cutters
Milling cutters possess a primary inclination angle and two types of rake angles: one is the radial rake angle (γf), and the other is the axial rake angle (γp). The radial rake angle (γf) primarily influences the cutting power, while the axial rake angle (γp) affects the formation of the chip and the direction of the axial force. When γp is positive, the chip flies away from the work surface.
Rake Angles (Contact Face of the Rake Face)
Negative rake angle: Used for steel, steel alloys, stainless steel, cast iron.
Positive rake angle: Used for sticky materials and some high-temperature alloys.
Neutral rake angle: Used for thread turning, grooving, form turning, and form tools. Whenever possible, a negative rake angle should be utilized.
02 Milling Cutter Geometric Shapes
(1) Positive Angle - Positive Angle Cutting is light and chip evacuation is smooth, but the cutting edge strength is relatively poor. Suitable for machining soft materials and stainless steel, heat-resistant steel, ordinary steel, and cast iron. This form should be preferred when machine power is low, the process system rigidity is insufficient, and when there is a build-up of swarf.
Advantages:
Smooth cutting
Smooth chip evacuation
Good surface finish
Disadvantages:
Cutting edge strength
Not conducive to cutting-in contact
Workpiece detaches from the machine table
(2) Negative Angle - Negative Angle Strong impact resistance, using negative type inserts, suitable for rough milling of cast steel, cast iron, and high hardness, high strength steel.
However, milling power consumption is high, and excellent process system rigidity is required.
Advantages:
Cutting edge strength
Productivity
Pushes the workpiece towards the machine table
Disadvantages:
Greater cutting force
Chip blocking
(3) Positive Angle - Negative Angle The cutting edge has strong impact resistance and is also sharp. Suitable for machining steel, cast steel, and cast iron. It also works well for large quantity milling.
Advantages:
Smooth chip evacuation
Favorable cutting forces
Broad application range
03 Milling Cutter Tooth Pitch
Close pitch: High-speed feed, higher milling force, small chip space.
Standard pitch: Conventional feed rate, milling force, and chip space.
Open pitch: Low-speed feed, lower milling force, large chip space.
If the milling cutter is not equipped with a dedicated finishing edge insert, the surface roughness depends on whether the feed per revolution exceeds the width of the insert's finishing edge plane.
Tooth Count:
Open pitch or standard pitch is used for slot milling (safety)
Close pitch is used for contour milling (productivity)






