Home > Knowledge > Content

Structure of the transposition milling cutter

Nov 27, 2024

Structure of Indexable Milling Cutters! Main Geometric Angles of Indexable Milling Cutters

A milling cutter has a primary rake angle and two cutting edge angles, one called the radial rake angle and the other called the axial rake angle. The radial rake angle (γf) and the axial rake angle (γp), the radial rake angle (γf) mainly affects the cutting power; the axial rake angle (γp) affects the formation of the chip and the direction of the axial force. When γp is positive, the chip flies away from the machined surface.

Rake Angles (Contact Face of the Front Face)

Negative rake angle: Used for steel, steel alloys, stainless steel, cast iron.

Positive rake angle: Used for sticky materials and some high-temperature alloys.

Neutral rake angle: Used for threading, grooving, form turning, and form tools.

Milling Cutter Geometric Shapes

Positive Angle - Positive Angle

Light cutting, smooth chip evacuation, but the cutting edge strength is relatively poor. Suitable for processing soft materials and stainless steel, heat-resistant steel, ordinary steel, and cast iron. This form should be preferred when there is a small power machine tool, insufficient rigidity of the process system, and the generation of built-up edge. Advantages:

Smooth cutting

Smooth chip evacuation

Good surface roughness Disadvantages:

Cutting edge strength

Not conducive to cutting contact

Workpiece detaches from the machine table

Negative Angle - Negative Angle

Strong impact resistance, using negative type inserts, suitable for rough milling of cast steel, cast iron, and high hardness, high strength steel.

However, milling power consumption is large, and excellent process system rigidity is required. Advantages:

Cutting edge strength

Production rate

Pushes the workpiece towards the machine table Disadvantages:

Greater cutting force

Chip clogging

Positive Angle - Negative Angle

The cutting edge has strong impact resistance and is also sharp. Suitable for processing steel, cast steel, and cast iron. It also works well for large allowance milling. Advantages:

Smooth chip evacuation

Favorable cutting forces

Broader application range

Milling Cutter Tooth Pitch

Close pitch: High-speed feed, high milling force, small chip space.

Standard pitch: Conventional feed rate, milling force, and chip space.

Open pitch: Low-speed feed, low milling force, large chip space. If the milling cutter is not equipped with a dedicated finishing insert, the surface roughness depends on whether the feed per revolution exceeds the width of the insert's finishing edge plane.

Tooth Count:

Open pitch or standard pitch is used for slot milling (safety)

Close pitch is used for contour milling (production rate)

Send Inquiry