Designing Complex Threaded Molds
In the plastic mold design industry, there is a wide variety of mold structures. For most mold designers, common slider and lifter structures are familiar and can be designed without much difficulty. However, when it comes to more specialized and typical mold structures, many designers feel at a loss on how to start. Today, I will explain the key points of designing threaded mold structures, hoping to inspire those who are interested in mold design and those who want to understand the thread extraction structure better.
Plastic product threads are divided into external and internal threads. For external threads with low precision, a half-block is generally used for forming, while internal threads mostly require a thread-unloading device. Here is a brief introduction to the methods of internal thread demolding and the use of gears:
Classified by action method: ① The threaded core rotates, and the pusher plate pushes the product away; ② The threaded core rotates and retracts simultaneously, allowing the product to naturally separate.
Classified by driving method: There are generally two types of thread-drawing molds: one driven by a cylinder with a rack motion, and the other driven by a motor with a chain motion.
The principle of thread extraction in mold: The pitch of the die set and the pitch of the product must be the same to ensure proper guidance. The cylinder drives the rack 1 to move - rack 1 drives gears 2 and 3 to rotate - gear 3 drives gear 4 to rotate - gear 4 is integrated with the threaded rod and rotates together.
When designing a thread mold, it is essential to know the pitch, which is defined as the vertical distance the thread moves in one complete rotation.
The pitch at the product's plastic position and the pitch of the threaded rod must be the same; otherwise, the product is prone to drag injuries.
The method of calling gears and racks: Hu Bo's external program can call gears and racks. Based on the product layout in our mold, we can determine the required pitch circle diameter for our gears, and as long as the gear module is the same, we can call out the gears.
The method of calling racks: The rule for calling racks with Hu Bo's external program also follows the formula (module × number of teeth = pitch circle diameter).
To design a thread mold, it is necessary to understand the relationship between racks and gears. The following diagram shows the relationship between racks and gears and the relationship of each gear.
Calculation of the number of turns required for product ejection and the calculation of the length of the rack: If the thread has 5 turns, the threaded rod needs to retract for at least 5 turns. The threaded rod retracts for 6 turns, and then you can calculate the rack's pulling distance based on the previous page.






