Home > News > Content

What Are The Maintenance Methods Of The Sprocket Wheel

Feb 06, 2023
  1.  The tightness of the sprocket should be appropriate. Too tight will increase power consumption and the bearing is easy to wear; too loose Shenyang sprocket is easy to beat and off-chain. The tightness of the sprocket is: lifting or pressing from the middle of the sprocket, about 2% -3% of the center distance of the two sprockets.
  2.  the sprocket installed on the shaft should be without swing and skew. In the same transmission assembly, the end surface of the two Shenyang sprockets shall be located in the same plane, as if the center of the chain wheel is below 0.5 m, and if the center is above 0.5 m. However, there can be no friction side phenomenon of the sprocket teeth. If the two wheels are too large, it is easy to produce delink and accelerated wear. Care must be taken to check and adjust the offset when changing the sprocket.
  3.  After the sprocket is seriously worn, the new sprocket and the new sprocket should be replaced at the same time to ensure good engagement. A new sprocket or a new wheel cannot be replaced alone. Otherwise, it will fail to accelerate the wear of the new or new sprocket joint. After the tooth surface is worn to a certain extent, it should be used in time (referring to the sprocket with adjustable surface) to extend the use time.
  4. The new sprocket is too long or elongated after use, which is difficult to adjust, and the chain can be removed according to the situation, but it must be an even number. The chain should be crossed from the back of the sprocket, the lock piece inserted outside, and the opening of the locking plate should be in the opposite direction of rotation.
  5. Shenyang sprocket should be filled with lubricating oil in time at work. The lubricating oil must enter the coordination clearance between roller and inner sleeves to improve working conditions and reduce wear.
  6.  The old sprocket can not be mixed with some of the new sprocket, otherwise it is easy to impact in the drive and break the sprocket.
  7. When the machine is stored for a long time, the sprocket should be removed and cleaned with kerosene or diesel oil, and then coated with oil or butter and stored in a dry place.

 

Send Inquiry